Trouble Shooting; Fault Table; Replacing The Led Lights - Bosch DWK065G 0 Série Notice D'utilisation

3Trouble shooting

Malfunctions often have simple explanations. Please
T r o u b l e s h o o t i n g
read the following notes before calling the after-sales
service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.

Fault table

Problem Possible cause
The appliance The plug is not
does not work plugged into the
mains
Power cut
The fuse is faulty
The lighting does The LED lights
not work. are defective.
--------
Solution
Connect the appliance to the
power supply
Check whether other kitchen
appliances are working
Check in the fuse box to make
sure that the fuse for the appli-
ance is in working order
You can read about this in the
section entitled "Replacing the
LED lights".

Replacing the LED lights

:
Warning – Risk of electric shock!
When changing the bulbs, the bulb socket contacts are
live. Before changing the bulb, unplug the appliance
from the mains or switch off the circuit breaker in the
fuse box.
:
Warning – Risk of injury!
The light emitted by LED lights is very dazzling, and can
damage the eyes (risk group 1). Do not look directly
into the switched on LED lights for longer than 100
seconds.
Important! Only use bulbs of the same type and
wattage.
Disconnect the appliance from the power supply.
1.
Remove the metal grease filter.
2.
Push the bulb out of the appliance from the rear.
3.
Turn the bulb a quarter turn anti-clockwise and
4.
remove it.
Replace the bulb with one of the same type.
5.
Insert the metal grease filter.
6.
Plug in the mains plug and switch the fuse back on.
7.
Trouble shooting
en
9