Lindy 32520 Manuel Utilisateur page 5

User Manual
Some Hotkey examples:
After pressing the SCROLL LOCK and entering the OSD mode, you have the option to type in
further hotkey command keys.
Direct Port Selection / Keyboard Hot Key Commands:
Within 2 seconds
↑ ↑ ↑ ↑
+ + = Previous Port +
Scroll Scroll
or
Lock Lock
+ +
↓ ↓ ↓ ↓
To access ports 1-8 of the KVM Switch directly you may use the following hotkey sequence:
Scroll + Scroll +
6
Lock Lock
To access ports 9-16 you should use the following hotkey
Scroll Scroll
+ +
E
Lock Lock
To use hotkey switching to access another cascaded KVM Switch / Bank:
Page Up or
Scroll Scroll
+ +
Lock Lock Page Down
OSD Main Screen
The OSD Main Screen is divided into left side for port / server selection functions and right side
for KVM configuration and administration functions.
Tip: Press the
arrow key
multiple times, to
Enter
cycle through the
ports
= Next Port +
= for Port 6 (For other ports replace Key "6"
with the corresponding Key 1-8)
sequence:
= for Port 13 (For other ports 9-16 replace Key "E"
as follows: A=9, B=10, C=11, D=12, E=13, F=14,
G=15, H=16)
Enter
= + Previous Bank (Up) or
=
Next Bank (Down)
7
English User Manual
The following table lists the indicators and their meaning. Please read it carefully!
USER1~8
S
-
+
R
↑ ↑ ↑ ↑
↓ ↓ ↓ ↓
PgUp
PgDn
1 1 BANK1
F1
F2
F3
F4
F5
ESC
SCAN RATE
VERSION
When functions from the right side OSD menu (F1-F5) are selected further OSD sub-menus will
be displayed for the appropriate functions. For F1 – Port Name Edit the following sub-menu will
show up. (Please note that the KVM Switch always assumes an English (QWERTY) keyboard
layout). Simply enter the name (up to 12 characters) you want to use for the highlighted port
and press F1 to save.
Indicates that a computer is connected to this port with 5V present at its PS/2
ports: powered on, standby or sleep mode (or even soft powered off depending
on its BIOS settings)
Indicates that the port is password protected. (Factory default is password OFF
Port name of corresponding port (factory default setting).
Indicates that this port is selected for Auto Scan Mode
Switches a beep confirmation tone ON and OFF whenever the hotkey is
pressed
To select ports 1-8 (sever port names 1-8) for OSD display
To select ports 9-16 (sever port names A-H) for OSD display
To RESET to factory default. (NOTE: not for passwords)
Select the computer at the previous port
Select the computer at the next port
Select the previous bank of cascaded KVM switches
Select the next bank of cascaded KVM switches
The first 1 indicates the selected KVM Switch/bank, the second 1 indicates the
active port
Go to the Edit Computer Name menu
Go to the Edit Security Settings menu
Edit the recently highlighted port Auto Scan setting ON/OFF
Go to Auto Scan submenu
Got to Edit Hot Key Setting menu (Scroll / NUM / Caps Lock)
Exit OSD
Go to the Edit Auto Scan / OSD Rate menu
Displays the firmware version (1.0)
8
English