P
A
. 5714
ERSONALISATION OF
RT
A series of personalisation operations are possible by programming
some parameters on the internal extensions.
There is the possibility of reading, cancelling and changing the
personalisation on all the articles listed.
To be able to use Pushbuttons 3 4, 5 and 6, the monitor must
contain the additional pushbutton card Art. 5733.
The optional card Art. 5734 allows Pushbuttons 3 and 4 to be used,
whereas there are 2 signalling LEDs in the positions of
Pushbuttons 5 and 6.
1
2
3
4
5
6
Fig. 4
The ones in figure 4 are the factory settings of the pushbuttons, but,
by means of Art. 1251/A, it is possible to personalise each
pushbutton of the monitor to carry out one of the following functions:
• Door-opening
• Call to porter switchboard
• Self-lighting
• Actuator
• Coded actuator
• Doctor
• Video request
• Intercom group call (not available on Art. 5714)
Furthermore it is possible to:
- Read the configuration of all the pushbuttons.
- Save the configuration of the pushbuttons read.
- Cancel the single pushbutton and therefore make it unprogrammed.
- Recall a user configuration of the pushbuttons to be programmed.
- Recall a pre-defined (factory) configuration of pushbuttons to be
programmed.
Additional sheet MT SB2 02
5714/I
AND
Selector for Bell /
Privacy Service
Door-opening
Call to porter switchboard
Self-lighting
Actuator
Actuator
Actuator
Doctor
LIST OF THE MENU FUNCTIONS
Hold mode
5714
• Pushbutton Prog.
• Pushbutton Key:
• Pushbutton 1: (as Pushbutton Key)
• Pushbutton 2: (as Pushbutton Key)
• Pushbutton 3: (as Pushbutton Key)
• Pushbutton 4: (as Pushbutton Key)
• Pushbutton 5: (as Pushbutton Key)
• Pushbutton 6: (as Pushbutton Key)
• Default Config.
• Saved Config.
• Pushbutton Read
5714/I
• Intercom Prog.
• Intercom Read.
• Canc. Intercom
• Pushbutton Prog.
• Pushbutton Key
• Pushbutton 1: (as Pushbutton Key)
• Pushbutton 2: (as Pushbutton Key)
• Pushbutton 3: (as Pushbutton Key)
• Pushbutton 4: (as Pushbutton Key)
• Pushbutton 5: (as Pushbutton Key)
• Pushbutton 6: (as Pushbutton Key)
• Default Config.
• Saved Config.
• Pushbutton Read.
• Output Read.
- Standard Funct.
- Reset pushbutton
- Standard Funct.
- Intercom Group
- Reset pushbutton
5
MT SB2 02