Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONTROL DISPLAY
Press Assist-X or Assist-Y.
Switching to walk assist mode
1.
Stop the bicycle.
2.
Release your feet from the pedals.
3.
Hold down Assist-Y until it reaches the following state (around two seconds).
4.
The assist mode shown on the display switches to [WALK].
If it is impossible to switch to walk assist mode for any reason (the bicycle is not stopped,
there is pressure applied to the pedals, etc.), a warning sound will be played.
If nothing is done for one minute after switching to walk assist mode, it will switch back to
the assist mode that was selected before switching to walk assist mode.
64 - EN
Publicité
Table des Matières
