EMG 1093023 Notice D'utilisation page 128

CONTROL DISPLAY
< Switch to walk assist mode >
* The Walk assist mode function may not
be able to be used in certain regions.
1. Press Assist-Y to switch the mode to
[OFF].
2. Press Assist-Y once again 2 seconds
until [WALK] is displayed.
3. Press and hold Assist-Y to start walk
assist.
When [WALK] is displayed, press and hold
down Assist-Y on the assist switch to start
the walk assist function.
Releasing Assist-Y stops the walk assist
function, or pressing Assist-X can stop the
walk assist function.
•Assist-Y is not operated for over 1
minute, the mode will change to [OFF].
• If the bicycle does not move after the
walk assist function turns on, the function
automatically stops. To restart the walk
assist function, release the assist switch
and press and hold down Assist-Y again.
• The walk assist function can operate at
a maximum of 6 km/h.
• The assistance level and speed vary
with the gear position
EN - 41