EMG 1093023 Notice D'utilisation page 118

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONTROL DISPLAY
KD21C LCD CONTROL DISPLAY
The control unit is integrated with the LCD
display and operates the drive system. It is
located on the handlebar in the left side
near the grip.
1. Control Unit Function Overview
1.1 Power Button ON/ OFF
Hold the "M" button for 2 seconds to switch
on/off the LED control unit and electric
drive system.
The system will automatically turn off if left
idling for more than 10 minutes.
1.2 Assist mode
Hold "+" or "-"
desired assist level for electric system. The
lowest is Level 1 and the highest is Level 5.
When powered on, the default is Level 1.
When there is no numeric power level
displayed it means the ebike is in park or it
functions as a standard bike with no assist
from the motor. You will feel the electric
assistance kicking in once selecting again
between Levels 1 up to 5.
EN - 31
buttons to select the
1.3 Lights/Backlit Button ON/OFF
With the display switched on, hold the "+"
button for 2 seconds to turn on/off the
headlight,
taillight
backlight.
1.4 Walk Asist
The ebike comes equipped with walk assist
function. This feature propels forward your
ebike with a constant speed of 6km/h
without pedaling and requires nothing but
to hold it balanced when walking along
side it. It comes very handy when needing
to push it up a steep incline.
Hold the "-" button to activate the walk
assist.
This function remains activated as long as
you hold the button and deactivates the
moment you stop holding it.
NOTE! Push Assist function should only be
used when the wheels are in contact with
the ground.
Danger of injury may occur if push assist
function is activated since the wheel (front
or rear depending on the motor location)
will start spinning.
and
the
display

Publicité

Table des Matières
loading

Table des Matières