Spinlock XX Clutch XX0812 Mode D'emploi page 21

ZS-LC/5 & ZS-LC/10 Load Display
Power Button
automatically power down.
Page Button
P and a reading.
the reading.
to zero.
BASIC INSTRUCTIONS ARE SHOWN ON THE BATTERY COVER
Zero Reset
40
www.spinlock.co.uk
spinlock_hi_load_A5_12_1.indd 40-41
Overload
OVERLOADING 200% OF SWL WILL RESULT IN PERMANENT DAMAGE TO LOAD CELL
Battery Life
range of load measured.
VERY LOW VOLTAGE BATTERIES MAY GIVE INACCURATE READINGS.
STORAGE WITH BATTERY INSTALLED CAN RESULT IN LEAKAGE AND DAMAGE.
Battery Replacement
appropriate sized screw driver.
same end as the wire exits the load cell body.
the seal is compressed an even amount all round.
DO NOT OVER TIGHTEN THE SCREWS
41
23/11/12 10:24:29