Spinlock XX Clutch XX0812 Mode D'emploi page 14

XXC0812, XXC0812/L, XX0812, XX0812/L Clutch
6. After removal, thoroughly clean all components and body with fresh water and inspect the
following critical items :
Roller Cages (both are identical) -
unclip from jaw and look for signs
of wear or flats on the roller surfaces.
If flats are found replace & consider
upgrade to XX-ROLL+
orientation.
Jaw Bearing Surfaces - ensure that
both are clean and smooth.
Jaw Grip Surfaces - clean off any rope debris. Check for excessive wear on the grip
surface. If the black anodised surface has aluminium showing through, replace with a new
XX-JAW or XXC-JAW assembly as appropriate.
Warning : do not use XXC-JAW in XX clutches as serious damage, harm and injury
could occure.
Jaw Spring - should be able to hold jaws apart, be a smooth shape and located on either
side of the top jaw.
Jaw Linkplates - check these are attached to both sides of both jaws with pins and secured
Release Pin - located centrally in top jaw. Check for any signs of surface wear.
Clutch Body - flush clean inside, paying particular attention to the upper and lower roller
surfaces, the two drainage runs in the base and their exits at the end mouldings.
Handle - do not remove this from the body. Check that the operation holds the handle in
the closed and fully open position (via the leaf spring mounted at the front of the wedge).
26
www.spinlock.co.uk
spinlock_hi_load_A5_12_1.indd 26-27
XX & XXC
ROLLERCAGE
FITMENT
FRONT BACK
4 HOLES TOWARDS
FRONT FOR BOTH
ROLLERCAGES
Re-assembly
1.
2.
3. Insert jaw assembly in body of XX.
4. Angle rear moulding backward, to locate lower fixing hooks in body.
5. Rotate top of cover into place flush with XX body.
6.
7.
opening and closing the handle fully.
8. For standard versions, open and close the handle fully to ensure fully operational.
9.
how to use
XX0812
pages 14-15
installation spares
27
pages 20-21 pages 36-37
23/11/12 10:24:17