Spinlock XX Clutch XX0812 Mode D'emploi page 10

ZS–RLB Remote Lockback Switch
For use with ZS1214, ZS1618, ZS1014C, ZS1618C, ZS1014B and ZS1618B Jammers or existing
1.
2.
2.
Remove rear block and jaw step ( see page 22).
3. Thread the control line through the spring and rear blockand fasten the rear block into place.
4. With the control line cut to approximately the correct length, splice the control line to the eye
18
www.spinlock.co.uk
spinlock_hi_load_A5_12_1.indd 18-19
5.
use bulls eyes or blocks to ensure a smooth run.
6.
splice so it is just taut.
7. Check operation as described (see page 12 and 13). Some adjustment may be necessary
before making the splice permanent.
8.
Closed
ZS-RLB
how to use spares
19
pages 12-13 pages 34-35
23/11/12 10:24:14