Focal FPS 2160 Manuel D'utilisation page 10

focal power Symmetric amplifierS
U s e r m a n u a l
3.5. You can now start the connection phase of the RCA, REMOTE and speaker cables. Connect the RCA
cables to the amplifier (pic. 5). When connecting RCA, be careful to respect the polarities (INPUT Left = black
or white, INPUT right = red). Then connect the cable(s) to the car radio.
pic. 5
Now connect the REMOTE cable to the amplifier (REM terminal) screwing tightly. Connect the other end of the
REMOTE cable to the car radio REMOTE terminal.
Finally, connect the speaker cables to the amplifier and make sure the polarities are correct (+ with + ; - with
-) by stripping 1cm of cable (pic. 3)
Connect the REMOTE CONTROL cable {only with the FPS 1500, FPS 2300RX and FPS 4160 references} to
the amplifier, then fix the remote control in the spot made for it (except for the FPS 2160 model).
3.6 - Get the positive (+) power supply cable ready for connection to the amplifier by removing 1cm of the
plastic coating from the end of it (pic. 3). Tin this part of the cable using a soldering iron and tin the wire.
Insert the plastic-free tinned part of it in the amplifier's "+ BATT" terminal, then secure the cable in place by
screwing it in tightly.
pic. 6
* If the car radio is not equipped with RCA outputs, high-level to low-level
adapters (speaker outputs that are used as RCA outputs) are available from
all Focal distributors. These adapters will enable the cables to be connected
via the car radio's speaker outputs instead of the requisite RCA outputs,
which they replace.
Autogood products Internet store "130"
9