Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. To add food or liquid while processor is running, remove small food pusher and insert
through the feed chute. Replace small food pusher in chute.
9. When finished, press the OFF|PULSE button and allow blades to stop revolving before
removing lid. Twist lid clockwise to remove from the workbowl.
Important: Be sure S blade has completely stopped spinning
and unplug appliance before removing lid from processor.
10. To unlock workbowl, turn it clockwise and lift off base.
11. Carefully remove S blade by pulling blade shaft straight up
and empty workbowl.
Note: To remove S Blade from blade shaft, turn
counterclockwise and pull blade shaft out from bottom. (I)
12. Unplug appliance when not in use.
HE LP FU L TI P S FO R USIN G T H E S BL AD E
•
The processor works very quickly, watch carefully to avoid over-processing foods.
•
For best results, process foods that are about the same size.
•
When chopping cooked or raw meat, the food should be very cold.
•
Processing nuts or other hard foods may scratch the surface finish on the inside of
the bowl.
•
Do not overfill the bowl.
•
Never walk away from the processor while it is on.
•
Use hot but NEVER boiling liquids.
•
The workbowl has a capacity of 4 cups (32 oz.) for liquid and 10 cups (80 oz.) for
dry foods.
USING TH E DO UGH BLA D E
Important: The dough blade can only be used with the large workbowl. Only run the
processor on LOW speed when using the dough blade.
1. Lock large workbowl onto base.
2. Place dough blade on blade shaft and turn it clockwise to
lock it onto bottom of shaft. You will feel it lock into place.
(J) Push dough blade and shaft down onto center post in
workbowl until it is fully seated.
3. Insert all the dry ingredients into the workbowl.
4. Place cover on workbowl. Secure large and small food
pushers in feed chute and process on LOW speed.
8
I
J
Publicité
Table des Matières
