Philips QS6160 Mode D'emploi page 10

EngliSh
10
4 Press the trimming head on/off button once to switch on the
trimming head.
, QS6160 only: The on/off button lights up to indicate that the
trimming head is operating.
5 To trim the hair, move the trimming comb through the hair slowly.
tips
- Always make sure that the tip of the trimming comb points in the
direction in which you move the appliance.
Make sure that the lat part of the trimming comb is always in full
-
contact with the skin to obtain an even hair length result.
- Since hair grows in different directions, you need to move the appliance
in different directions as well (upward, downward or across).
- You can switch on the trimming head while the shaving head is
operating. If you do this, the shaving head is switched off immediately.
- Trimming is easier when the skin and hair are dry.
When you are inished, press the trimming head on/off button again
6
to switch off the trimming head.
trimming without comb
The comb keeps the trimming head at a set distance from your head. You
can use the trimming head without comb.If you use the trimming head
without comb, your hair is cut off close to the skin (approx. 0.5 mm).
1 To remove the comb, pull it off the appliance.
Never pull at the lexible top of the comb. Always pull at the bottom part.
2 Press the trimming head on/off button to switch on the trimming
head.
3 Hold the appliance with the trimming head pointing upwards and
make downward strokes with the broad side of the trimming head.