Vortice Vario C02 Notice D'emploi Et D'entretien page 36

ENGLISH
Time programming of the sensor regulator SCO2-IAQ
To access the time programming mode, in normal operating mode press MODE continuously (2s aprox) until the user menu appears on
the screen (date setting, time
programming, identifier, parameters and reset). Using the UP and DOWN keys, select PrOG and press MODE, accessing that instant
to time programming mode
Note: During the time programming mode, the probe controller does not communicate through the serial communication channel
In time programming mode the functions of the pushbuttons are as follows:
- ON/OFF:
Short Pulsation (press): Exits the time programming mode.
Long Pulsation (press) (~1s): Copies the schedule from the day before to the current day. Icon is displayed as confirmation of the copy
of the day.
- MODE: Select the period (day, periods 1 and 2, and reduced period), and the setpoints for those periods.
- UP/DOWN: Modify the value of the hour and the corresponding setpoint.
Mode time
schedule
Example of time programming:
Monday programming
Period 1 Start: 8:00
End: 13:00
Period 2 Start: 15:00
End: 18:00
36
MON TUE WED THU FRI SAT SUN
Day selected for programming
MON Monday
TUE Tuesday
WED Wednesday
THU Thursday
FRI Friday
SAT Saturday
SUN Sunday
Scheduled time
Hour
Unscheduled time
Scheduled period
Start Period 1
Period 1
End Periodo 1
Start Period 2
Period 2
End Periodo 2
The reduced period is that period outside
Reduced period
scheduled hours for period 1 and 2.