User Menu - Vortice Vario C02 Notice D'emploi Et D'entretien

ENGLISH

User Menu:

■User menu: With UP and DOWN you select the mode to access. To enter the selected
mode, press MODE. To exit, press ON / OFF.
■Date setting (HOrA): With MODE the data to be modified (day/hour) is selectedand with UP and DOWN the value is modified. With
ON/OFF you exit the datesetting and return to normal operating mode
■Configuration of time schedules (PrOG): With MODE the data to be modified (day/period) is selected, and with UP and DOWN the
value of the corresponding hour is modified. To deactivate the period, put the hour in value -- :-- . With ON/OFF you exit the configuration
of time programming returning to normal operating mode. See SCO2-IAQ sensor regulator time programming.
■Identifier display (ıd): The identifier configured in the drive is displayed through serial communication.
The display is done by 5 digits of 7 segments: 0 1 2 3 4 5 6 7 8 9 A b C d E F
88888
D1 D2 D3 D4 D5
■Parameter's Mode (PAr): With MODE, the parameter to be displayed is selected, and with UP and DOWN the value of the same is
modified. With ON/OFF the parameter mode is exited, returning to the normal operating mode. See SCO2-IAQ controller parameters.
■Reset (rESET ): When resetting the sensor regulator, the display shows "-----", the operation starts again after a few seconds.
32