Adjust The Doors; Refrigerator Use; Using The Controls - Whirlpool WRT518SZFM Instructions D'utilisation

Adjust the Doors

Your refrigerator has two adjustable rollers - one on the right and
one on the left. If your refrigerator seems unsteady or you want
the doors to close easier, adjust the refrigerator's tilt using the
instructions below.
1. Turn the leveling leg to lower or raise that side of the
refrigerator. It may take several turns to adjust the tilt
of the refrigerator.
■
To raise, turn the leveling leg to the left.
■ To lower, turn the leveling leg to the right.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling legs and
rollers which makes it easier to adjust.
2. Open both doors again to make sure they close as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling legs to the left; it may take several more
turns.
NOTE: To keep the refrigerator level, you should turn both
leveling legs the same amount.
3. Using a level, be sure that the refrigerator is still level side to
side. Readjust if necessary.

REFRIGERATOR USE

Using the Controls

Your refrigerator has a high-tech, easy-to-use electronic control
feature located on the inside of the refrigerator compartment.
The first time you plug in the refrigerator:
The first time you plug in your refrigerator, all of the electronic
control indicators will flash simultaneously.
Temperature Control
Your refrigerator is equipped with a Smart temperature control.
You can use it to set the refrigerator compartment temperature
as needed.
To set the refrigerator compartment temperature:
The product is set to the recommended temperature at the
factory. To adjust that temperature, simply press the Setting
button. This will decrease the refrigerator temperature. The setting
change is unidirectional, from Cold to Coldest (left to right). Once
the control is in the Coldest position, it will move to the least-cold
setting (Cold) if pressed again.
This is the coldest temperature (Coldest) in the product. All the
indicators will be ON.
The least-cold temperature setting will be shown with the first
indicator (left to right) ON.
The median minimum temperature will be displayed when you
press the Setting button once from the least-cold temperature.
The second indicator will be ON.
The "Recommended" temperature will be shown with the third
indicator ON.
The fourth indicator will come on when you press the Setting
button once from the recommended temperature.
NOTE: To switch off the refrigeration system, press the Setting
button for 4 seconds and then release it. No indicator will remain
on. This will lead the refrigerator and freezer to stop cooling, but
the electricity is not disconnected.
To switch the refrigeration system back on, press the Setting
button for 4 seconds and then release it.
9 9 9