Installation Tips - INVENTOR PR1-ION10L Manuel De L'utilisateur

Installation tips

3) Ensure the filter is clean.
4) Place unit in vertical
operating position and
allow 2 hours before
initial use in order to avoid
malfunctions.
EN
1) Do not block or restrict
the airflow around the
unit. Make sure the air
inlet exhaust grills are not
obstructed. Allow 20cm of
clearance around the unit
and 40cm above.
2) Place the unit in an area
where the temperature
levels will not fall bellow 5ºC
(41ºF) There is a possibility
the coils will collect frost at
temperatures that are under
5ºC (41ºF), which may result
in low performance.
5) Before the initial operation, please check,
if the water level switch, located within the
water bucket area, is in the right position.
7