Installation Tips - INVENTOR EVP-WF16L Manuel D'utilisateur

Installation tips

3) Ensure the filter is clean.
4) Place unit in vertical
operating position and allow
2 hours before initial use in
order to avoid malfunctions.
EN
1) Do not block or restrict the
airflow around the unit. Make
sure the air inlet exhaust grills are
not obstructed.
clearance around the unit and
40cm above.
2) Place the unit in an area
where the temperature levels
will not fall bellow 5ºC (41ºF)
There is a possibility the coils
will collect frost at temperatures
that are under 5ºC (41ºF), which
may result in low performance.
(Working conditions: 5°C-32°C,
30%RH–80%RH).
5) Before the initial operation, please check, if
the water level switch, located within the water
bucket area, is in the right position.
Allow 20cm of
15