Select Cycle; Pull Control Dial Out To Start - Maytag MAV-1 Guide D'utilisation Et D'entretien

STEP 3

Select Cycle

To select a cycle, push the control dial in (off position)
and turn it to the right (clockwise) until the pointer is at
the soil level needed for the wash load in the Regular,
Wrinkle Control or Delicates cycles.
Regular Cycle
Provides normal agitation and normal spin speeds to
wash cottons and heavily soiled items. For maximum
cleaning, set the dial at Extra Heavy.
Wrinkle Control Cycle
Provides normal agitation and slow spin speed to
protect wrinkle control fabrics.
Delicates Cycle
Provides slow agitation speed and slow spin speed for
delicates and knits.
STEP 4
Select Options
Extra Rinse
When the switch is in the On position, an additional
rinse at the end of the Regular, Wrinkle Control and
Delicates cycles is provided to more completely
remove laundry additives, suds, perfumes, etc.
End of Cycle Signal
The End of Cycle Signal will sound once the cycle is
completed. The End of Cycle Signal can be canceled by
setting the switch to Off.
STEP 5

Pull Control Dial Out to Start

You may stop the washer at any time by simply
pushing the control dial in. Therefore, it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed in (off position) when you change the setting.
Note:
Do not attempt to turn the control dial
counterclockwise. Damage to the timer will result.
Control features vary by model.
(if desired)
(select models)
6