Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL CONNECTION AND USING YOUR REFRIGERATOR
Electrical Shock Hazard
•
Do not use an extension cord with this ap-
pliance. They can be hazardous and cause
deficient operation.
•
This unit should not, under any circumstances,
be installed to an un-grounded electrical supply.
•
Do not remove the grounding prong from the
power cord.
•
Do not use an adapter.
•
Do not splash or spray water from a hose on
the appliance. Doing so may cause an electri-
cal shock, which may result in severe injury or
death.
Electrical Connection
A grounded 115 volt, 15 amp dedicated circuit is required.
(A separate circuit serving only this appliance).
This product is factory equipped with a power supply
cord that has a three-pronged, grounded plug. It must be
plugged into a mating grounding type polarized receptacle
located near the product. The product and receptacle
should be installed in accordance with the National Electri-
cal Code and applicable local codes and ordinances (see
Figure 4). If the circuit does not have a grounding type
receptacle, it is the responsibility and obligation of the cus-
tomer to provide the proper power supply.
NOTE
Ground Fault Circuit Interrupters (GFCI) are prone to
nuisance tripping which will cause the unit to shut down.
GFCI's are generally not used on circuits with power equip-
ment that must run unattended for long periods of time, un-
less required to meet local building codes and ordinances.
Figure 4
Setting the temperature control:
Initially set the cold control midway between the numbers
three (3) and four (4). After at least 2 hours adjust to the
temperature that suits you. The higher the number you
select, the cooler the temperature. (See figure 5). The tem-
perature range of the refrigerator is from 33° to 52°F
(1° to 11°C).
Figure 5
5
Cold control
underneath door
in grille
Publicité
Chapitres
Table des Matières
