Care And Cleaning; Cleaning And Maintaining Dispensing System; Tap Cleaning Kit; Faucet Cleaning - AGA marvel 61HK Instructions D'installation, D'utilisation Et D'entretien

Masquer les pouces

Table des Matières

Les langues disponibles

Cleaning and Maintaining Dispensing System

The dispensing system needs to be cleaned between us-

age to prevent spoilage and/or foul taste in your beer.

Tap Cleaning Kit

This is an optional item (part number 42242373) Kit in-

cludes everything to quickly clean tap. Includes cleaning

solution, pump, mixing bottle, brush and wrench.

Faucet Cleaning

Turn off the gas supply with the shutoff valve under the

regulator (see Figure 22) and open the faucet to relieve

the pressure. To remove the faucet from the tower use the

spanner wrench provided. Place the pin on the wrench

into the hole on the faucet collar and turn clockwise ↷ to

remove the faucet. (See Figure 27).

Remove the knurled cap from the faucet body just below

the handle and pull the handle assembly from the faucet.

This will allow the shaft to be removed from the back of the

faucet, see Figure 26.

After removing the

handle the shaft will

slide out the back of the

faucet

Soak all faucet parts in hot clear water or a solution of hot

water and a sanitizing solution. Do not use soap.

Reassemble faucet, assemble faucet to tower (be sure

faucet is in off position), and turn on gas valve.

Keg Coupler Cleaning

Remove the keg coupler from the keg if necessary. Close

the gas valve below the regulator, remove both the red

gas line and clear beer line from the keg coupler using a

1" open end wrench or an adjustable wrench. Remove the

90°elbow from the top of the keg coupler, see Figure 28.

Soak all parts in hot water or a sanitizing solution. Dry all

parts and reassemble.