Leister WELDPLAST S4 Instructions D'utilisation page 24

Welding parameters – Programming
Menu
Select program
Scroll
Enter
• The hand extruder is suitable for the following types of thermoplastic: PP/PE-HD/PE-LD
• Programs 1 – 3 include the relevant preset values, which can be adjusted during the course of the welding
process.
• The adjustments are not saved!
• The free settings 1 - 4 are factory set and can be freely programmed. The parameters remain saved after
the tool is switched off.
Welding program
Free settings 1 – 4
Prg1 PE-LD
Prg2 PE-HD
Prg3 PP
Prg4 PVC
• The welding program (17) currently set is shown in the operating display.
Switching off the tool
• Release the locking device (4) of the motor on/off switch (2) as applicable, and then let go of the motor on/off
switch (2). Remove welding material in the welding shoe in order that the welding shoe is not damaged with the
next start.
• Switch off the heating with the Standby / Enter key (26).
• Let the tool to cool down for approx. 5 min.
• Switch off at the main switch (1).
24
Target PLAST [°C]
230
220
230
230
170
Free
setting
1-4
Target AIR [°C]
260
260
260
260
260