Bemer 3000 Mode D'emploi page 85

LED minute display turns off, abnormal sequence of running lights
and audible signal.
Cause
No applicator connected.
(e.g. coil mat, intensive applicator)
BEMER Control detects no signal,
applicator or control unit defective.
Problems with the BEMER Control
No indicator light
Cause
Battery discharged.
No acoustic signal
Cause
Control unit not switched on.
Connected applicator is defective.
BEMER Control is defective.
Solution
Press the STOP button.
Connect an applicator to the control
unit and select the desired treatment
level.
Send the applicator and / or the
control unit to the manufacturer
or a manufacturer authorized dealer.
Solution
Replace with a new 9 V block
battery.
Solution
Press the ON button.
Send the applicator to the manu-
facturer or a dealer authorized
by the manufacturer.
Send the BEMER Control to the
manu facturer or a dealer authorized
by the manufacturer.
85
english