Bemer 3000 Mode D'emploi page 80

11.3 Coil mat
The control unit indicates the correct function of the coil mat.
- No error message
- Check the coil mat with the BEMER Control
11.3.1 Intensive applicator
The control unit indicates the correct function of the intensive
applicator.
- No error message
- Check the intensive applicator with the BEMER Control
- Double check with optional accessories e.g. coil cushion
11.3.2 Checking function with the BEMER Control
Move the slide switch to the ON position. The control light
beneath will light up. When switched on, the BEMER Control
registers each electromagnetic field within 30 to 500 Hz.
Point the sensor area towards the area to be tested.
If an electromagnetic field is present, an acoustic signal will sound.
For example, the electromagnetic field around the power supply
unit can be used for this functional test. If you point the BEMER
Control towards the power supply unit, an acoustic signal will
sound.
80
english