Unit Description; Initial Use; Setting Up The Control Panel - Sanitas SBG 43 Mode D'emploi

Les langues disponibles

repairs

IMPOrtAnt

• Never open or attempt to repair the unit yourself, as otherwise proper function is no longer

guaranteed. Failure to observe this regulation shall void the warranty.

• If you need to have the unit repaired, contact customer service or an authorised dealer.

4. unit description

Overview

1. Control panel with display

2. SET/ON button

3. Down key

4. Up key

5. Receiver

6. Scale

7. Transmitter

8. LED

9. Wall mount

Inserting batteries

If present, pull the battery insulating strip off the battery compartment cover or remove the battery's pro-

tective film and insert the battery in the scale and the control panel with the correct polarity. Note the gra-

phic in the battery compartment.

control unit

2 x CR2032 3 V lithium batteries

Scale

4 x 1.5 V AAA batteries

If the scale fails to operate, remove the batteries completely and reinsert

them.

For instructions on changing the batteries, see p. 23.

changing the weight unit

On delivery the scale is set to the unit „kg". A switch located on the back of the control panel enables you

to change to „pounds" (lb).

Setting up the scale

Set up the scale on a level and solid surface. A solid surface is a prerequisite for a correct measurement.

Positioning the control panel

The control panel can be held in the hand, attached to the wall mount or be left on the scale.

4 x 1,5 V Typ AAA

Table des Matières