Cleaning And Maintenance - vitapur VWD1006W Guide D'utilisation Et D'entretien

Adjusting the Temperature (Cold water only)
All GHP Energy Star Water Dispensers are shipped from the factory with the cold water
temperature control positioned at the "Energy Star Qualification Level" setting identified
to the side. This setting will deliver cold water temperatures between 8° ~ 10°C (46.4°F ~
50°F) The cold water temperature can be adjusted, (using a flat screwdriver) by rotating the
adjustment screw clockwise or anti-clockwise between "High" (cool) and "Low" (colder)
TEMP
until the desired temperature is reached. NOTE: Any change/adjustment to the cold water
temperature control may effect Energy Consumption. If the water dispenser is not dispensing
water, there could be a possible ice build-up due to the cold water temperature control being
set too cold. If this happens, unplug the dispenser overnight and then reset. Set thermostat
to high, slowly increasing based on your use and need for cold water.
High
Low
COLD WATER
Dispensing Hot Water
The Kettle Feature dispensing system on this unit is designed to save energy and money.
Conventional hot water dispensing systems operate 24/7 regardless of water usage. The
(on demand) Kettle Feature activates the hot water system "only" when the Kettle Feature (red) button is activated
delivering steaming hot water in less than 3 minutes.
To stop/cancel the Kettle Feature during a cycle, simply press the Kettle Feature button a second time and the red LED
light will stop flashing.
IMPORTANT NOTE: Your Vitapur® water dispenser is designed with a special "safety" feature (float switch
mechanism) that controls activation/operation of the Kettle Feature hot water tank heating system. If no water is
present and/or low water levels are detected inside the internal water reservoir, activation/operation of the Kettle
Feature hot water heating system is not possible. Likewise, if the hot water heating system is operational and
water is being drawn simultaneously causing internal water levels to drop below the established minimal level set
point, hot water tank operation is automatically suspended. To reactivate the hot water heating system, you must
replenish your water supply.
Child Resistant Safety Switch
To prevent hot water from being dispensed accidentally and possible harming a child,
the hot water dispensing button can only be operated when the child resistant safety
switch is activated. To dispense hot water, push the child safety switch sideways, (in
the direction of the arrow located on the switch) from right to left, then depress the hot
water button until the desired amount of hot water is dispensed. Upon releasing the hot
FIG. 7. Child Resistant Safety Switch
water button, the child safety lock automatically returns to the locked position. (figure 7)
DANGER: The hot water is heated to approximately 194˚ F / 90˚C. Temperatures above 125˚ F / 52˚ C can cause
severe burns from scalding. DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING
BUTTON WITHOUT PROPER AND DIRECT SUPERVISION.
Cleaning Kit

CLEANING AND MAINTENANCE

Like most appliances, your water dispenser requires periodic maintenance for
maximum efficiency and performance and must be cleaned on a regular basis (i.e.
every 4 months). To maintain a hygienic environment within your water dispenser
and prevent potential formation (growth) of bacteria, we strongly recommend regular
cleaning. A cleaning kit is available through our Customer Service Department at
1-877-447-4768 or can be ordered on line at www.ghpgroupinc.com. Please see
"Initial Product Cleaning Procedure" and follow instructions.
Available online at
www.ghpgroupinc.com
7