Sony LSPX-P1 Guide De Référence page 9

Masquer les pouces Voir aussi pour LSPX-P1:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
exposed to direct sunlight or close to a
heater. Heat may build up in the unit
causing a fire.
On AC adaptor and cables
• Do not damage the power cord. It may
cause a fire or electric shock.
• Be sure to use the supplied AC adaptor
with the unit. If a different AC adaptor is
used with the unit, it may cause a fire,
electric shock or malfunction.
• Do not touch the power plug with wet
hands. It may cause an electric shock.
• Before making connections with the AC
adaptor and connection cables, turn off
the unit and connected equipment, and
unplug the power plugs from the wall
outlet.
• Do not wrap the power cord or
connection cable around the AC adaptor.
It may cause the cord or cable to break.
• Before moving the unit, disconnect the
power cord and connection cables. The
cables may be damaged resulting in a fire
or electric shock, or connected equipment
may fall or topple over causing injuries.
• Insert the connector straight. If it is
inserted at an angle, pins may make a
short circuit causing a fire.
On fan noise
A fan is incorporated inside the projector to
prevent overheating, and this makes a
slight noise while turned on. This noise is
not a malfunction. However, if there are any
abnormal noises, consult qualified Sony
personnel.
On light source maintenance
This unit uses a laser, therefore special
caution and facilities are necessary for the
inspection and maintenance of light source
components. Be sure to consult qualified
Sony personnel.
On cleaning
• Be sure to turn the unit off and unplug it
from the wall outlet before cleaning.
• If the unit is rubbed hard with a dirty
cloth, the unit may be scratched.
• If volatile liquids such as insecticide are
sprinkled on the unit, or an item made of
rubber or vinyl stays in physical contact
with the unit for a long time, the unit may
be affected or the surface color may fade.
• Do not touch the projection window with
bare hands.
• To clean the surface of the projection
window:
Gently wipe it with a soft cloth such as an
eyeglass cleaning cloth. If there are
stubborn stains, wipe them up with a
cloth moistened with water. Never use
alcohol, benzene, thinner, acidic cleaning
agents, alkaline cleaning agents, abrasive
cleaning agents, chemical dust cloths,
and so on.
• To cleaning the exterior:
9
GB

Publicité

Table des Matières
loading

Table des Matières