Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before start-up
Abb. 5:
Incorrect
Do not place the ground clamp on the
‰
welding machine or the gas cylinder;
otherwise the welding current will be ca-
rried via the protective conductors and it
will destroy these.
12 .5
Insert the welding wire spool
Open side panel and turn the retaining nut
Â
20 off from the wire spool holder 22.
Place the welding wire reel on the decoiler
Â
mandrel and ensure that the carrier mandrel
23 locks in position.
For small welding wire reels, use an adap-
Â
tor (order number 620.9650.0).
Set the wire brake 21 so that, when the
Â
torch switch is released, the welding wire
spool just does not run on.
22
21
20
Abb. 6:
Decoiler mandrel
01.10
23
12 .6
Thread the wire electrode in
Unscrew the contact tip of the torch.
Â
Open side panel.
Â
The diameter of the wire electrode must
Â
agree with the legible embossed figure on
the wire feed rollers 25.
Swing the tilt levers 27 to the side and
Â
thread the wire electrode through the inlet
nozzle 26 and central socket 11.
26
27
25
Abb. 7:
open 2-roll wire feed
26
27
25
Abb. 8:
open 4-roll wire feed
Swing the lever back 28 and secure in po-
Â
sition with the sweel levers 27.
28
11
28
28
27
25
11
- 37 -
Publicité
Chapitres
Table des Matières
Dépannage
