Bosch MUZ8FW1 Notice D'utilisation page 8

en
Then adjust the fastening screw until the

pulp flows out with the required moisture.
Place the food to be processed in the

filling tray.
Use the pusher to push in ingredients.
Set rotary knob to setting 7.

Biscuit attachment MUZ8SV1
for shaping biscuit dough or short pastry.
Fig. 
Preparation as described for mincer

attachment. Note required individual
parts and sequence when assembling
the biscuit attachment.
Place the dough to be processed

in the filling tray.
Use the pusher to push in ingredients.
Set rotary switch to setting 1–5 depending

on dough consistency.
Separate the shaped dough coming

out of the appliance with a pastry cutter.
Briefly switch off the food processor
if the dough comes out too quickly.
Grater attachment MUZ8RV1
for grating almonds, nuts, cooled chocolate
and dried bread or rolls.
Warning!
Process only dry nuts and almonds in small
quantities!
Fig. 
Preparation as described for mincer

attachment. Note required individual
parts and sequence when assembling
the grating attachment.
Place the food to be processed

in the filling tray.
Use the pusher to push in ingredients.
Turn rotary switch to setting 1–5 depen-

ding on hardness of the food.
Sausage filler set MUZ8WS2
for filling all types of sausage, for shaping
croquettes.
Fig. 
Preparation as described for mincer

attachment. Note required individual
parts and sequence when assembling
the sausage filler set.
Place the food to be processed

in the filling tray.
Use the pusher to push in ingredients.
Set rotary knob to setting 3–7.

8
Noodle attachments MUZ8NS1
For shaping dough sheets (lasagne, ravioli)
and noodles (ribbon noodles, macaroni,
rigatoni, etc.) from prepared dough.
Fig. 
Preparation as described for mincer

attachment. Note required individual
parts and sequence when assembling
the noodle attachments.
Insert attachment for dough sheets

(lasagne) into the mincer and attach
with the threaded ring of the mincer.
or
Place the worm gear extension on the

worm gear of the mincer, ensuring that
the spiral continues smoothly.
Insert required attachment into the cone

and attach with the threaded ring of the
noodle attachment.
Follow the instructions in the separate instruc-
tions for use for this optional accessory!
Perforated disc set MUZ8LS4
Perforated disc with 4.5 mm hole diameter
Perforated disc set MUZ8LS5
Perforated disc (hole diameter 3 mm, 6 mm
and 8 mm)
Adapter MUZ8AD1 with coupling part
Is required for attachment of the mincer
MUZ8FW1 and the pasta attachments
MUZ8NV1/NV2 and NV3 to the base unit.
Is included in the product package
of the mincer MUZ8FA1.
Robert Bosch Hausgeräte GmbH
Subject to alterations.