Hlubricating The Horizontal Columns; Itesting The Safeties Of The Machine - Cassese MACH 1CART Manuel D'utilisation

USER MANUAL
5.H LUBRICATING THE HORIZONTAL COLUMNS
Allen Key N.3
Clean cloth with lubricant spray such as WD40
Engine car oil
Refer to chapter I.5.A SAFETY INSTRUCTIONS(page 21) for safety instructions.
Remove the side panel as explained in the chapter I.5.G REMOVING THE SIDE PANEL
(page 24).
Clean with clean cloth the 2 horizontal columns and apply some engine car oil on
them.
5.I TESTING THE SAFETIES OF THE MACHINE
Make sure the machine will switch ON/OFF when using the red button.
This button should remain in pushed position (OFF) until you rotate it to release it.
If not, contact your local agent to replace the button assembly.
Set the machine in manual mode.
Unlock the handle of the sliding table and move the table far away from the clamps. Do
not put your hands on the table.
Remove mouldings from the table and try to press the pedal.
The machine shouldn't try to shoot the wedges and the message "ALARM: READJUST
TABLE" should be displayed. If the message is not displayed, then contact your local
agent for repair.
MACH 1 CART
Figure 5-16
Figure 5-17
Figure 5-18
25