Cspecific Use Of The Spacer Bars; Dadjustment Of The Sliding Table - Cassese MACH 1CART Manuel D'utilisation

USER MANUAL
3.C SPECIFIC USE OF THE SPACER BARS
When joining small
mouldings (lower
than the height of
the back fences), it
is necessary to use
the set of spacer
bars supplied with
SPACERS
the machine.
The spacer bars are
made of two steel
bars linked with a
screw locked by a
nut. The nut side is
the bottom side of
the spacer bars
3.D ADJUSTMENT OF THE SLIDING TABLE
The sliding table (see
page 5) needs to be
adjusted to be able to
set the various
stapling positions.
To do this, switch on
the Pre-Clamp button.
Shift the sliding table
in order to tighten
both mouldings with
the rebate clamp
(see page 5).
Then tighten the
sliding table handle .
This is an example of a
bad setting, the spacer
bar not being used will
cause the top clamp to
touch the fences and
not to
moulding correctly. The
moulding will jump up
during stapling.
Figure 3-4
Here the
bars are
down. The nut is
visible on the top,
which is not correct.
Figure 3-6
Unscrew the sliding
table handle.
Put the spacer bars
against the sliding
table if needed (see
previous chapter).
Figure 3-8
With the
clampling button still
in ON position, press
CLEAR button
clear what
already
memory
machine
selected favorite.
Figure 3-10
hold the
spacer
upside
pre-
to
was
in the
of the
for the
MACH 1 CART
Figure 3-5
Figure 3-7
Figure 3-9
Figure 3-11
14