Programming The Machine - Cassese MACH 1CART Manuel D'utilisation

USER MANUAL
4

PROGRAMMING THE MACHINE

After performing the adjustments of chapter 3 (ADJUSTMENTS). Perform the following procedure:
Put on the table only
one chop of
moulding against the
fence.
This will allow easy
visualization of
stapling positions
Use the arrows to get
the wedge distributor
moving to the
desired position.
Touch the button
POSITION NUMBER to
program the second
position (if required).
The black back ground
digid shows the
selected position.
Touch the
POSITION
several times to achieve
the position you wish to
program.
Number one is the first
position that will be
executed, number 5 will
be the last one.
The MACH 1 CART can
start from the back or
from the front of the
moulding.
Figure 4-1
Touch several times
the button WEDGE
QUANTITY until the
desired value
displayed.
Figure 4-3
Repeat
procedure
Figure 4-3.
In this example, we
have programmed
favorite 1 (F1):
1 wedge in position1
and 2 wedges
postions 2 at 11mm
(measured from the
rebate).
Figure 4-5
button
NUMBER
is
same
from
in
MACH 1 CART
Figure 4-2
Figure 4-4
Figure 4-6
19