Fresetting The Maintenance Alarm; Gremoving The Side Panel - Cassese MACH 1CART Manuel D'utilisation

USER MANUAL
If you can't push down the protruding Wedge/driver blade, then put your hands on
top of the vertical column and give a shock down. An audible "clack" sound should
confirm the hammer is unlocked.
Try to apply procedure I.5.C
remove the distributor and be able to remove the jammed hammer. If the distributor
head can't be removed, apply again a shock down and try to remove the distributor.
5.F RESETTING THE MAINTENANCE ALARM
When the machine
requires lubrication
of the distributor
head, this message is
displayed briefly at
power up.
In that case, switch
off the machine and
perform the
lubrication of the
distribution block.
5.G REMOVING THE SIDE PANEL
Allen Key N.3
In order to have an access to mechanical parts, it is imperative to remove the side
panel of the opposite side to the screen.
With the 3mm Allen Key, unscrew the 4 locking screws.
Then remove the side panel.
REMOVING THE DISTRIBUTOR HEAD (page 22) to
Never push with your finger on a protruding wedge, they are very sharpened!!!
Figure 5-13
Then switch back on the
machine. When the
machine ask to press a
button, press the clear
button.
As soon as the alarm
message is displayed,
press again the clear
button. The clear button
must be pressed while
the alarm message is
displayed. If you were
too late, then switch
back off the machine
and try again the
procedure.
MACH 1 CART
Figure 5-12
Figure 5-14
Figure 5-15
24