Setup; Unpacking The Machine - Cassese MACH 1CART Manuel D'utilisation

USER MANUAL

2 SETUP

2.A. UNPACKING THE MACHINE
Cutter
Flat span N.13 & N.17
Allen key N.5
Cut both plastic strips
in order to free the
box and lift up the
wood cover with the
help of a second
person.
After unpacking the
machine, install and
set the 4 feet to level
the machine. Make
sure the 4 feet are
touching the floor,
machine must be
steady.
One is located under
the keyboard. Use
Phillips screw driver if
you wish to change
the position of the
screen.
When levelling the machine, if the machine is installed against a working table, make sure a long frame will
not be risen up by the table, because this would cause bad joining. Working table and machine should be
levelled together.
Bubble level
Phillips screw driver
Using the
span, remove the 4
bolts to free
machine from
crate. They
located under
pallet.
Figure 2-2
The keyboard is hold
in place with
screws.
2 are located on top
of the keyboards, use
5mm Allen key to
remove them if you
wish to change the
position of
screen.
.
Figure 2-3
The keyboard
can be installed on
the other side of the
machine.
Figure 2-5
13mm
the
the
are
the
3
the
then
MACH 1 CART
Figure 2-1
Figure 2-4
Figure 2-7
10