Connect The Cable To The Alarm Assembly; Install The Alarm Assembly - Allegion Schlage CONNECT Mode D'emploi

8b Connect the cable to the Alarm Assembly.
L Locate the screws in step 8d before beginning this step so they will be handy when you
need them.
8c Install the Alarm Assembly.
1. Align the tab with the notch as shown.
2. Route the cable into the channel.
3. Then slide the Alarm Assembly towards the door.
10
Route the cable into
the channel to avoid
crimping the cable.
The connector fits only one
way. Match the dot on the
connector with the dot on the
circuit board.
Align tab with
notch.