Kenwood DPX791BH Mode D'emploi page 32

INSTALLATION / CONNECTION
Installing the unit (in-dash mounting)
Do the required wiring ( 31)
Dashboard of your car
Installing in Toyota cars
(for
Install onto the car brackets using the screws (commercially available). Use the mounting holes (
) that fit the car brackets. Then, install the supplied trim plate (C).
(
Do the required wiring. ( 31)
Dashboard of your car
Use only the specified screws. Using wrong screws might damage
the unit.
30
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
)
Car bracket
When installing without the mounting sleeve
1
Remove the mounting sleeve from the unit.
2
Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
screws (commercially available).
How to remove the unit
) or
1
Fit the catch pin on the extraction keys into the holes
on both sides of the trim plate, then pull it out.
2
Insert the extraction keys deeply into the slots on
each side, then follow the arrows as shown below.