Items Supplied - SilverCrest SHBS 600 A1 Mode D'emploi

BB*5$B%ERRN 6HLWH  'LHQVWDJ  1RYHPEHU    
sponds to the specifications on the rat-
ing plate. The wall socket must continue
to be easily accessible after the device
is plugged in.
~ Ensure that the cable cannot be dam-
aged by sharp edges or hot surfaces.
~ Ensure that the cable is not trapped or
crushed.
~ When removing the power unit from the
wall socket, always pull the power unit
and never the cable.
~ Pull the power unit out of the wall sock-
et, ...
... after every use,
... after each charging process,
... if there is a fault,
... before connecting the device to the
power unit,
... before you clean the device and
... during thunderstorms.
~ To avoid any risk, do not make modifi-
cations to the device. Repairs must be
carried out by a specialist workshop or
the Service Centre.
DANGER from batteries
~ Protect the battery against mechanical
damages. Fire hazard!
~ Do not expose the device to direct sun-
shine or heat. The ambient temperature
should not be lower than 10 °C and
higher than 40 °C.
~ The charge contacts on the device must
not be connected by metallic objects.
~ The battery may only be charged with
the original accessory (power unit).
~ The battery only removed for disposal
must not be used again.
~ Should the electrolyte solution leak out
of the battery, avoid contact with eyes,
mucous membranes and skin. Rinse im-
mediately with plenty of clean water
and consult a doctor. The electrolyte
solution can cause irritation.
6
GB
WARNING! Risk of injury from
cutting
~ The tips of the comb attachments and
trimmer attachment are sharp. Handle
with care.
~ Do not use the device if the attachment
shows damages.
~ Switch off the device before pinning up
or changing the attachments and each
time before cleaning.
WARNING! Risk of injury
~ Place the cable in such a way that no
one trips over it or steps on it.
~ Do not use the device on open wounds,
cuts, sunburn or blisters.
WARNING! Risk of material
damage
~ Use the original accessories only.
~ Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
~ Do not cover the power unit to prevent
overheating.
~ Do not use any astringent or abrasive
cleaning agents.

4. Items supplied

1 Hair and beard trimmer|4
1 Power unit|8
1 Holder / battery charger|9
1 Trimmer attachment|3
6 Comb attachments|1 for trimmer attach-
ment|3:
4–6 mm / 7–9 mm / 10–12 mm /
16–18 mm / 22–24 mm /
28–30 mm
1 Thinning out attachment|2
1 Comb|13
1 Scissors|10
1 Cleaning brush|12
1 Blade oil|11
1 Travel case (for the hair and beard trim-
mer and its accessories)|14
1 Hairdressing cape|15
1 Operating Instructions