Setup Instructions; Install Batteries; Prepare The Probe - General PalmScope DCS950 Guide De L'utilisateur

E. button. Enlarges video
frame up to 4X. Each
button press increases
zoom level by factor of
0.5
F. button. Decreases
brightness of
4 camera LED lights
G. Lanyard attachment bar
H. Lens cap
I. Camera head
J. Flexible-obedient
probe
K. Probe exit port
L. Clamshell latches
M. Battery compartment
N. Battery compartment
screws

SETUP INSTRUCTIONS

INSTALL BATTERIES

The PalmScope's battery compartment
(Fig. 2, Callout M) is accessible from the
back of the unit.
6
K
N
L
M
To install batteries,
Use a Phillips-head screwdriver to
loosen the two screws securing the
battery compartment cover (Fig. 2,
Callout N). Remove the cover and set
it aside.
Load four "AAA" batteries into the
compartment, using the polarity
markings within it as a guide
Replace the battery compartment cover
and secure it by tightening the Phillips-
head screws.

PREPARE THE PROBE

To gain access to
the probe, flip the
PalmScope over so
its back faces you,
place your thumb
and index finger at
the positions marked
OPEN (Fig. 2, Callout L), and gently
squeeze the latches (see figure above).
The clamshell case will pop open.
Note that the probe is tightly wrapped
within a twisting channel that makes
two full turns around the inside of the
clamshell. The probe can be uncoiled
7