Operating Instructions; Quick Start Procedure - General PalmScope DCS950 Guide De L'utilisateur

• The pickup hook lets you retrieve
otherwise inaccessible items seen by
the probe—for example, a wedding
ring accidentally dropped down a sink
drain.
• The magnetic pickup lets you retrieve
lost or dropped metal objects—nuts
and bolts, for example—located by the
probe.
• The thread protector keeps the camera
head and its threads from being
scratched or damaged by anything the
probe bumps into.
Attach the thread protector before you
use The PalmScope for the first time.
Remove it before attaching any of the
three other accessories. Reattach the
thread protector after removing an
accessory. Never expose the threads of
the probe tip to the dangers of an
inspection session.
OPERATING
INSTRUCTIONS

QUICK START PROCEDURE

1. Before you use the PalmScope for the
1
first time, carefully peel off and discard
the plastic film protecting the LCD.
2. Remove the black rubber lens cap
(Fig. 2, Callout H) from the end of the
probe.
3. Press and hold the
Callout D) for at least 3 seconds to
power on the unit and illuminate
the LCD.
4. Point the camera-tipped end of the
probe at the target of interest, pushing
the probe through holes or bending
the probe around objects if necessary.
Avoid bending the delicate probe
excessively; this will damage it.
5. Press the button (Fig. 2, Callout B)
to increase the brightness of the
camera's LEDs
6. Press the button (Fig. 2, Callout F)
to decrease the LEDs' brightness
7. Press the button (Fig. 2, Callout C)
to flip the video (rotate it 180°). Press
the button again to undo the
inversion. Use the arrow stenciled on
the camera head to orient video up
and down (for example, to read text or
serial numbers).
button (Fig. 2,
11