Setup Instructions; Install Batteries - General iBORESCOPE4 Manuel D'utilisation

1. WiFi status light:
Green light on and steady = Preparing hot spot
Green light flashing slowly = Hot spot ready, device(s) not connected
Green light flashing quickly = Hot spot ready, device(s) connected
Green and red light on and steady = Low battery
2. Power switch/brightness thumbwheel
3. Battery compartment
5. Threaded hole for attaching included smartphone holder or mounting
iBorescope4 upside down on tripod
6. Reset button. Press with end of pin or needle and hold for 10 seconds to
reset iBorescope4's WiFi Service Set Identifier (SSID) and password to the
factory defaults of "iSNAKESCOPE" and "12345678", respectively.
7. Magnetic pickup
8. 45° mirror
9. Pickup hook

SETUP INSTRUCTIONS

INSTALL BATTERIES

iBorescope4's battery compartment is accessible from the bottom of the pistol
grip.
To install batteries,
1. Slide the battery compartment cover in the direction of
the arrow marked on it.
2. Extract the battery magazine from the grip by pulling on
the tab at its end (see upper figure at right).
3. Load four "AA" batteries into the magazine, using the
polarity markings within it as a guide (see lower figure
at right).
4. Push the loaded magazine back into the grip (it fits only
one way).
5. Replace the battery compartment cover, pushing it forward until it
snaps shut.
4. Camera head
8
9
7
5