Cleaning And Storage - Fysic FW-400 Mode D'emploi

Press the timer button to switch on the FW-400.
Repeatedly press this button to set the timer.
1st LED: 15 minutes
2nd LED: 30 minutes
3rd LED: 45 minutes
4th LED: 60 minutes
When the lamp is illuminated while no LED is enabled, the light will remain lit
without using the timer.
press 1x
Lamp always on 15 mins
Indicator
You may press and hold the timer button for at least 2 seconds to switch off
the lamp.
Press the + and – buttons to increase or decrease the light intensity.
Model:
Dimension (W x H x D):
Weight:
Lighting elements:
Light intensity:
Intensity level:
Color temperature:
Time:
Operating conditions:
Storage conditions:
Power adapter:
Never use any aggressive cleaning products. Only clean the FW-400 with a
moist cloth. Make sure that no water enters the device. If this does happen,
immediately disconnect the device and let it fully dry before the next use.
Protect the device against dust, chemicals, humidity and extreme
temperature changes and keep it away from appliances that generate heat
(ovens or heaters).
Store the lamp in the original packaging when not using it for a long period of
time.
press 2x press 3x
30 mins
TECHNICAL SPECIFICATIONS
Fysic FW-400 / TLW002
155 x 129 x 136mm
0,3Kg
LED - Full Spectrum Bright White
10.000 lux at 10cm Maximum level
5 steps adjustable
5300K ±300K
4 steps in 15, 30, 45 and 60mins.
00C to 350C, 15-90% relative humidity
-200C to 500C, 15-90% relative humidity
AC 100~240V, 50/60Hz / 24VDC 1,5A

CLEANING AND STORAGE

-24-
press 4x press 5x
45 mins 60 mins
press 6x
always on