Mi-Scan Test; Adjusting Stimulation Intensities - Compex RUNNER Mode D'emploi

MI-SCAN TEST

N.B. See the chapter "How MI technology works".
If the MI-sensor cable is connected, the MI-scan test starts immediately after the programme is selected.
A Press the on/off button to stop the test
The +/- buttons of the 4 channels are inactive throughout the test.

ADJUSTING STIMULATION INTENSITIES

When you start a programme, you are asked to increase the stimulation intensities.
This step is essential for a successful session.
1
Programme duration in minutes and seconds
2
Programme progression bar. For details of how it works, see the following paragraph: "Programme progression"
A Press the on/off button to switch the unit into Pause mode.
B C D E The four channels flash, going from + to 000. The stimulation intensity must be increased to be able to start
stimulation. For this, press the + buttons of the relevant channels until the desired setting is reached.
N.B. To increase the intensities on several channels simultaneously, press the I-button and then increase the intensities. The
interdependent channels are displayed in white on a black background.
A
2
1
A B C D E
EN
12