Starting A Programme - IKEA TVATTAD Mode D'emploi

ENGLISH
3. If desired, set one or more options by
touching the related buttons. The related
indicators illuminate.
If a selection is not possible an
acoustic signal sounds and the
display shows

Starting a programme

Touch the Start/Pause
programme. The related indicator stops
flashing and stays on. It is not possible to
start the programme when the indicator of
the button is off and doesn't flash (e.g.
programme knob on a wrong position).
The programme starts, the door is locked.
The display shows the indicator
The drain pump can operate
shortly before the appliance fills
water.
Starting a programme with the delay
start
1. 1. Touch the Delay Start
repeatedly until the display shows the
desired delay time. On the display the
indicator shows
2. Touch the Start/Pause
appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start
repeatedly until the display shows
the indicator
3. Touch the Start/Pause
to start the programme immediately.
.
button to start the
.
button
button. The
.
button to
button
goes off.
button again
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause
to start the new countdown.
The AutoAdjust System load
detection
The programme duration in the
display is referred to a medium/
high load.
After touching the Start/Pause
the maximum declared load indicator goes
off, the AutoAdjust System starts the laundry
load detection:
1. The appliance detects the load in the first
30 seconds. In the programmes where
FlexTime is available, during this phase
the FlexTime bars
time digits play a simple animation. The
drum rotates shortly.
2. The programme duration could be
adjusted accordingly and could increase
or decrease. After further 30 seconds,
the water filling starts.
At the end of the load detection, in case of
drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause
and
programme again. The AutoAdjust phase
can be repeated up to three times (see point
1).
27
button to
button
button again
button,
placed below the
is
button to start the