Gianantoni - Genius BRAIN 15 Instructions Pour L'utilisateur

Pagina 12 BRAIN 15
Guide for the installer
1. WARNINGS
2. LAYOUT AND CONNECTIONS
3. TECHNICAL SPECIFICATIONS
3.1. Description of components
3.2. Description of terminal-boards
3.3. Anti-crushing function
3.4. Over pushing stroke
4. PROGRAMMING OF THE LOGIC
5. PROGRAMMING THE SPEED
6. START-UP
6.1. Leds check
6.2. Programming the Dips-switch
6.3. Time - setup learning
7.INSTALLATION OF BUS ACCESSORIES
7.1. Addressing the BUS photocells
7.2. Memory storage of BUS accessotries
7.3. Memorising the BUS encoder
8. MEMORY STORING THE RADIO CODE
8.1. Memory storage of 868 radio controls
8.2. Memory storage of 433 radio controls
8.3. Radio controls deletion procedure
9. BATTERY KIT (OPZIONAL)
10. AUTOMATED SYSTEM TEST
11. FUNCTION LOGICS
CE DECLARATION OF CONFORMITY
Manufacturer: GENIUS S.p.A.
Address: Via Padre Elzi, 32 - 24050 - Grassobbio- Bergamo - ITALY
Declares that: Control unit mod. BRAIN 15
• conforms to the essential safety requirements of the following EEC directives:
•
2006/95/EC Low Voltage directive.
•
2004/108/EC Electromagnetic Compatibility directive.
Additional information:
This product underwent a test in a typical uniform configuration (all products manufactured by GENIUS S.p.A.).
Grassobbio, December 30, 2009
Read this installation manual to the full before you begin installing the product.
The symbol indicates notes that are important for the safety of persons and for the good condition of the automated system.
The symbol
INDEX
Notes on reading the instruction
draws your attention to the notes on the characteristics and operation of the product.
page.13
page.13
page.14
page.14
page.14
page.14
page.14
page.14
page.14
page.15
page.15
page.15
page.15
page.16
page.16
page.17
page.18
page.18
page.18
page.18
page.19
page.19
page.19
page.20
Managing Director
D. Gianantoni