Gianantoni - Genius BRAIN 13 Mode D'emploi

. WARNINGS
2. LAYOUT AND CONNECTIONS
3. TECHNICAL SPECIFICATIONS
3.. DESCRIPTION OF COMPONENTS
3.2. DESCRIPTION OF TERMINAL-BOARDS
4. PROGRAMMING THE LOGIC
5. PROGRAMMING THE SPEED
6. START-UP
6.. LEDS CHECK
6.2. PROGRAMMING THE DIPS-SWITCH
6.3. PRE-FLASHING
6.4. TIME - SETUP LEARNING
7. INSTALLATION OF BUS ACCESSORIES
7.. ADDRESSING THE BUS PHOTOCELLS
7.2. MEMORY STORAGE OF BUS ACCESSORIES
8. MEMORY STORING THE RADIO CODE
8.. MEMORY STORAGE OF 868 RADIO CONTROLS
8.2. MEMORY STORAGE OF 433 RADIO CONTROLS
8.3. RADIO CONTROLS DELETION PROCEDURE
9. BATTERY KIT (OPZIONAL)
0. AUTOMATED SYSTEM TEST
. LOGIC TABLES
Manufacturer: GENIUS S.p.A.
Via Padre Elzi, 32 - 24050 - Grassobbio- Bergamo - ITALY
Address:
Declares that: Control board mod. BRAIN 13 with 230 Vac power supply,
• conforms to the essential safety requirements of the following EEC directives:
73/23/EEC and subsequent amendment 93/68/EEC.
89/336/EEC and subsequent amendment 92/31/EEC and 93/68/EEC
Additional information:
This product underwent a test in a typical, uniform configuration. (all products made by GENIUS S.p.A)
Grassobbio, 15-08-2007
The symbol indicates notes that are important for the safety of persons and for the good condition of the automated system.
The symbol
INDEX
CE DECLARATION OF CONFORMITY
Notes on reading the instruction
Read this installation manual to the full before you begin installing the product.
draws your attention to the notes on the characteristics and operation of the product.
Managing Director
D. Gianantoni
7
page.8
page.8
page.9
page.9
page.9
page.9
page.9
page.9
page.9
page.9
page.9
page.9
page.0
page.0
page.0
page.
page.
page.
page.
page.
page.
page.2