HoMedics BPA-2000-EU Mode D'emploi page 7

IB-BPA2000-0912-01:Layout 1 09/01/2013 17:50 Page 7
This product uses the Oscillometric Measuring method to detect blood pressure. Before every measurement,
the unit establishes a "zero pressure" equivalent to the air pressure. Then it starts inflating the arm cuff,
meanwhile, the unit detects pressure oscillations generated by beat-to-beat pulsatile, which is used to
determine the systolic and diastolic pressure, and also pulse rate.
The device also compares the longest and the shortest time intervals of detected pulse waves to mean time
interval then calculates standard deviation. The device will display a warning signal with the reading to
indicate the detection of irregular heartbeat when the difference of the time intervals is over 25%.
SETTING DATE, TIME AND MEASUREMENT UNIT
It is important to set the clock before using your blood pressure monitor, so that a time stamp can be
assigned to each record that is stored in the memory. (year: 2000–2050, time: 24 H)
1. When the unit is off, hold pressing
"SET" for 3 seconds to enter the
mode for year setting.
2. Press the "MEM" to change the
[YEAR].
3. When you get the correct year,
press "SET" and it will turn to the
next step automatically.
4. Repeat step 2 and 3 to set
the [MONTH] and [DAY].
M D
6. Repeat step 2 and 3 to set the [UNIT].
mmHg
Yr
Yr
Yr
5. Repeat step 2 and 3 to set
the [HOUR] and [MINUTE].
MEM
SET
MEM
SET
SET
MEM
SET
MEM
SET
MEM
SET
kPa
7. After the unit is set , done will
show, then turn off automatically.
7