Suevia 130.8721 Mode D'emploi page 10

Three options of frost protection:
1. Heating element 24 V, for installation into the trough
(see separate mounting instructions)
Heating element 24 V, 180 W (Ref. 131.6063) for installation into the trough.
131.6063
2. Heating element 24 V, for installation under the trough
(see separate mounting instructions)
Heating element 24 V (Ref. 131.6060, 131.6061, 131.6062) for installation under the trough.
For power supply a SUEVIA Transformer 230/24 V is necessary.
For automatic switch on/off of transformer a thermostat (Ref. 101.0389) can be additionally installed. To
ensure a frost-free feed pipe, a frost protection heating cable 24 V, 20 W, 2 m (Ref. 101.0861), or a 24 V,
30 W, 3 m (Ref. 101.1863) has to be used. The heating cable should be wrapped around the pipe and
connected to the heating element of the drinker in parallel to the power supply cable, coming from the
transformer. If this heating cable is installed on plastic pipes, make sure that this water pipe is suited for warm
and cold water. For better heat distribution the water pipe has to be wrapped first with an aluminium adhesive
tape (Ref. 101.1099). The frost protection heating cable and the supply line should be protected against
animal bites or other damages.
131.6062 131.6061 131.6060
3. Connection to a water circuit with a circuit pipe
Max. 6 troughs can be connected to one circuit.
in stainless steel (Ref. 131.0590) suited for installation into all flat tip-over troughs. If
connected to a water circuit and in combination with a SUEVIA heating unit, frost protection is reached for the
water line as well as for the water in the trough.
131.0590
10