Regulatory Notices; About Electro-Magnetic Interference - Christie LW502 Mode D'emploi

Regulatory notices

About Electro-Magnetic Interference

This is a Class A product. In a domestic environment this projector may cause
radio interference in which case the user may be required to take adequate
measures.
This projector may cause interference if used in residential areas. Such
use must be avoided unless the user takes special measures to reduce
electromagnetic emissions to prevent interference to the reception of radio and
television broadcasts.
In Canada
CAN ICES-3(A) / NMB-3(A).
In the US and places where the FCC regulations are applicable
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user is required to
correct the interference at his own expense.
INSTRUCTIONS TO USERS: Some cables have to be used with the core set.
Use the accessory cable or a designated type cable for the connection. For cables
that have a core only at one end, connect the core to the projector.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
LW502/LWU502/LX602 Setup Guide
020-001101-03 Rev. 1 (02-2018)
As with any bright source, do not
stare into the direct beam, RG2
IEC 62471-5:2015.
3