Cleaning And Maintenance; Breakdowns - Bartscher EROSBM Mode D'emploi

ANY MANIPULATION AUTOMATICALLY EXCLUDES THE MANUFACTURER'S
LIABILITY AND THE WARRANTY ON THIS PRODUCT

5. Cleaning and Maintenance

WARNING:
Before any cleaning operation unplug
the device from the electrical system.
Never wash the appliance with water
jets in order to prevent water seepage
in the electrical components.
Clean the appliance at the end of the service. The tank
has to be emptied from the water inside through the
drain cock (see image on the right). Place a bucket
under the drain cock and turn the lever, make sure it is
closed once the tank will be emptied
It is recommended to dry it up with a cloth or a sponge.
The laminate parts can be cleaned with a damp cloth- In case of stubborn stains, use a
damp cloth with some alcohol, do never use corrosive or abrasive detergents.
The manufacturer is not responsible of any structural damage caused
by the use of damaging substances.
The trolley must always stand horizontally and shall never be turned.

5.1 Breakdowns

Problem
The appliance doesn't warm up
The lamps don't light up
Possible Reasons
Power failure
One or more heating elements are
burned
The power cable is worned out
The thermostat is broken
The control switch doesn't work
One or more lamps are burned
9
Drain cock
Solutions
Check the power presence in the
electrical system
Contact the retailer
Replace the cable with a suitable
one
Contact the retailer
Contact the retailer
Replace the lamps with new 250W
infrared lamps