Reset; Feedback Information; Service; Preventive Maintenance - Robert Juliat TIBO 535 Manuel

4.8.4 Reset

• Reset to default settings:
Menu: Fixture Reset → press Select → Yes & press Select to validate

4.8.5 Feedback information

• DMX and system LED feedback (see display & controls 7 , on page EN-18):
⇒ Green= DMX512 frame detected
⇒ Red = Problem on DMX512 frame and/or system default – details available
• If DMX512 data lost, the following message is displayed:
The last received DMX values are stored but it is possible to inactivate the current values
by pressing the Select key (as well as the Master function) in order to get a total control of
the fixture locally. When a DMX signal is detected, the DMX control is active again.
¥
•
Switched off – no symbol
Slow intermittent display
Continuous display
Rapid intermittent display

5 Service

5.1 Preventive maintenance

5.1.1 Frequency

General maintenance should be performed at least once a year or more frequently if
the equipment is operated in adverse conditions (smoke, heat, humidity, touring, etc.).

5.1.2 General cleaning

Remove dust from the unit (air vents, printed circuit boards, etc.).
• Fan blades must be locked.

5.1.3 General visual check

• No trace of heat.
• No loose contacts.
• No missing parts.
• Tighten mechanical assemblies (screws, bolts and nuts, ground connections, etc.).
in the fixture status
"Push select to reset DMX values"
signal indicates a wireless DMX: (not available for the Variable White version)
Signal
The fixture is not paired with a transmitter
The fixture is paired with a transmitter but the DMX signal is not
detected
The fixture is paired with a transmitter and the DMX signal is
detected
Lost connection with the transmitter or in connection with the
transmitter
During cleaning:
• LED is protected by a safety glass to avoid any contact.
DO NOT spray directly onto the glass.
Information
EN - 19 -
EN