Bowers & Wilkins ISW-3 Mode D'emploi page 7

Screw the support bar (j) to the top of the cowl as
shown using the three No.6 x 25mm (1in) screws (m)
into the pre-drilled pilot holes (Figure 21).
Remove the backing paper and apply the two self-
adhesive gasket strips (f), one to the support bar
and one to the cabinet at the other side of the louvre
frame. These will bear on the drywall panel to avoid
rattles (Figure 22).
Bring the subwoofer close to its intended position.
Strip the ends of the cable and connect it to the
spring terminals, observing the correct polarity. Then
secure the cable to the cowl using the cable tie to
prevent rattles (Figure 23).
Using the support block if required, offer the
subwoofer into position, with the support brackets
sitting in the rebates in the studs. Screw the
brackets to the studs (screws not supplied)
(Figure 24).
When secure, you may remove the temporary
support block.
a
j
m
Figure 21
Figure 22
+
Figure 23
m
x 3
f
f
f
Figure 24
7